Rear Seal Systems
ADDING OUR REAR SEAL SYSTEM TO YOUR EXTRUDER WILL IMPROVE YOUR SANITATION.
Ever Extruder Rear Seal Systems are engineered against leakage or contamination. This gives you better sanitation control in your plant. Safety is also improved as there is no product leaking onto the plant floor.
WHY CHOOSE EVER EXTRUDER
REAR SEAL SYSTEM?
Sanitation Improvements - Ever Extruder Rear Seal prevents raw product from escaping between the inlet barrel and inlet screw.
Prevents raw material from backing up and damaging the bearings and seals of the transmission system.
Keeps raw ingredients from leaking out of extruder and onto the floor.
Diamond-Hard-Carbide and stainless steel components give multi-year seal life.
The proven solution for rear seal leakage.
Systems are available for
X165 X185 and X235 series extruders. Available for bearing house or direct-drive gearbox systems.
Corrosion-resistant, stainless steel inlet head is available for ee-216 (X-185) series extruder.
Available for bearing house or direct-drive gearbox systems
Corrosion-resistant, stainless steel inlet head is available for ee-216 (X-185) series extruder
“After over 4 years of using the Ever Extruder Rear Seal System on our 216mm extruder, it shows NO signs of contaminated seals, or leakage! We will continue to add these to our other extruders as we rebuild them.”
“Two years after rebuilding our 216mm extruder with the Ever Extruder Carbide Protected Screws, we realized we should have invested in your Rear Seal System. During the rebuild to install the Rear Seal System, we evaluated the screws with approximately 10,000 hours - which showed minimal wear. We were able to reuse all the screws except #6……which wasn’t really that bad.
“In regards to the Ever Extruder Rear Seal System, yours speaks for itself. I have been here for 11 years and this is the longest I have seen a back seal last, ( by far).”
FOR MORE INFORMATION